Installing Post And Rail Fence On A Slope

Therefore premeasuring is a must.

Installing post and rail fence on a slope.

By running the fence following the slope of the ground you this method will produces an unleveled fence top. There are two different methods that can be used when installing fencing on a slope or a hill and this depends on the style of fence chosen. If they are not then be assured that you have successfully installed the fence on a slope. The problem is that few landscapes are laid out in 8 foot or 11 foot increments.

Set up the fence line. If you are using chicken wire you can use a staple gun to attach it firmly to the posts and rails. However there will be no visible gaps between the ground and the bottom of the fence. When building a fence on uneven terrain one option is to follow the contours of your yard.

The gap between the bottom of the pickets and the ground remains consistent throughout the entire fence creating a uniform look. Using a level to make it horizontal. Installing a fence on a hill seems like a daunting project but with the proper planning you can tackle it just as easily as a fence on level land. With raked fences this is often simple because once the fencing section is constructed you can rake it by moving the top rail into place.

Once you have the panels or posts set in the ground unroll enough wire mesh to reach to the next post and stretch over any rails. The point at which it crosses the second post will be the top of that post. The layout of the fence is somewhat determined by length of the precut fencing rails. This means that the horizontal rails of your fence will follow your yard in a smooth line that is parallel to the ground rather than level.

Near west chester pa. Shorten the overall length of the fence to accommodate the length of the precut rails. Use a measuring wheel to ensure you have the posts where they need to be before you install. When installing a fence on a hilly area there are three methods you might utilize to successfully install a fence around your property.

After you are done with the installation of the planks you can trim off the posts that are too high above the planks. Use the 4 inch marker on the first post as the reference for the bottom comer of the first wood panel or section of metal fencing. With the parallel method also called racked fence the fence follows the contours of the slope. Tie the other end to the next post and level the line.

To make a fence fit the landscape there are several options. Now that you are well aware of the how to build a fence on a slope you may also like to brush up your knowledge about building a fence. If you re constructing a slat and rail fence or picket attach one end of the bottom rail at that mark and extend the rail to the next post. Then simply follow the product s instructions to properly fit the fence to your lawn.

The rails on a contour fence follow the slope of the ground. A scalloped partial privacy fence installed on a slope by the fence authority.